wilsongarden – https://www.wilsongardenpots.com/
Because in the process of taking and placing and transportation, special take and place devices and pallets need to be used to ensure that taking and placing can be carried out in batches. The temperature is also normal. Watering must be thorough. There is a large amount of evaporation in summer, so it needs more watering. In winter, it is windy and easy to dry. In spring, it needs less water. Because usually, if the slow seedling is successful, even if some orchids pull out several small buds, they find that they will not continue to grow.
Hydrangea, as the name suggests, is in clusters when flowering. It is as beautiful as hydrangea. It is a very eye-catching and eye-catching ornamental flower plant. You need to immerse the seeds in 500mg / kg gibberellic acid solution for 24h, air dry and then sow. Label the 100 gallon fabric pots. In case of such pests, we must deal with them as soon as possible. In the early stage, if the time is prolonged, it will easily lead to the loss of too much nutrients and wither of lilac.
The film shall be paved again only when there are bubbles. In case of water leakage, the film shall be replaced and compacted with soil after water test. It can be completed at one time by mechanization or mechanical sowing. Other procedures can be completed manually. When the conditions are not met, it can also be completed manually. Then use the punch to punch the hole on the hole plate with a depth of 0.8 ~ 1.0cm to ensure the consistency of sowing depth and emergence time.
The used acupoint disc can also be disinfected with 50% carbendazim wettable powder and reused to improve the utilization rate of acupoint disc and reduce the production cost. A barbed wire mesh with a mesh spacing of 3.5 cm. The soil for seedling cultivation consists of a garden soil, a compost and a watering can. The sowing depth is about 1cm. After sowing, cover with vermiculite or matrix, pour water through and see the water droplets flowing out of the bottom hole of the hole plate.
The seedlings with 5 ~ 6 leaves use 72 cell seed trays. Sowing after air drying or pelleting treatment. After Hydrangea blooms, pay attention to removing the flower stems to promote the generation of new branches, which can maintain the beautiful shape of the plant. Timely supplement fertilizer and add ferrous sulfate to organic fertilizer appropriately, which can not only supplement nutrients, but also increase the acidity of soil. The designs and colors are also rich and changeable, which is very resistant to appreciation. Hydrangea is a treasure in the field of flowers and plants.
When it is long enough, it can be broken down for cutting. When cutting a bud, spray water immediately. The leaves need to be cut off. Cut them with a cross knife from 1cm above the bud, and the lower part looks like flat cutting. We need to strip the xylem from the cortex. Many basin friends raise Hydrangea tall and thin, and the flowers are small and few, but they don’t know what’s going on.
We can also apply some potassium dihydrogen phosphate to the plant and configure it to be applied at the concentration of 0.2%. We can also use superphosphate instead. The whole day shall be covered with light within 1 ~ 3 days after the connection, and the light shall be covered at 10 a.m. and 3 p.m. after 3 days, and the light shall be seen at other times. It will cause the basin soil to be too wet, which is contrary to its growth habit of not liking humidity.
The basin is a bit deep. If you use black plastic plant pots, you should use crushed charcoal blocks or hard plastic foam blocks on the bottom of the basin to enhance ventilation and drainage and prevent rotten roots. Hydrangea was cultivated earlier in China. Hydrangea was planted in Jiangnan gardens built in the Ming and Qing Dynasties. Its design and color can change from white to red and from red to blue due to the influence of pH. Or excessive soil moisture and poor soil ventilation may lead to non balling and loosening.
Spinach is a common vegetable throughout the year. It has rich nutritional value and good taste. Many people like it. Sowing from June to July, when sowing, the border surface shall be watered with enough bottom water first. The sowing method can be strip sowing or sowing, and the seed consumption per mu is 2.5 ~ 3kg. In case of high temperature and drought, water a small amount for many times to keep the soil moist and prevent the coriander from poor growth or death due to water shortage.